Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Ariens Modified & Repowered 1032 (pics)

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
jrtrebor


Location: Michigan - 3 hours north of Chicago on the lake
Joined: Feb 10, 2010
Points: 539

Ariens Modified & Repowered 1032 (pics)
Original Message   Nov 10, 2011 10:35 pm
Finally got the electrical straightened out, I hope (with help from some on this board)
and finished up everything else.

Removed the 11hp Honda clone engine that I put on last year and replaced it with a 13hp Honda GX390
with a 10A lighting coil.  Rewired everything.  Added a stainless shield on the front of the blower
Still have to get a new battery.  And hose it down with Fluid Film. But other than that it's ready to go.
Had some snow and sleet today.




Serrated the Augers.  Replaced the auger shaft bushing setup with flange bearings
Replaced the impeller bearing.  Gave everything a fresh coat of paint.




Tapered the deflector 3/8" on both sides to tighten up the stream a little




Fabricated a new belt cover.




Modified the starter cover to cover the Rectifier and wiring.




Removed the old steel shields on the front of the chute and replaced them with stainless ones.
When I had the wheels off I realized that I could thread in some 1/2 bolts from the back side of the
wheel plate to make studs.  Then use car lug nuts to hold the wheels on.  Now all the threads are protected from the
weather inside the lug nuts.  I'm keeping my eyes open for a pair of cheap 8" moon hub caps.



This message was modified Nov 10, 2011 by jrtrebor
Replies: 57 - 58 of 58Next page of topicsPreviousAllView as Outline
jrtrebor


Location: Michigan - 3 hours north of Chicago on the lake
Joined: Feb 10, 2010
Points: 539

Re: Ariens Modified & Repowered 1032 (pics)
Reply #57   Jan 27, 2015 10:42 pm

Thank you all, for all the nice comments.  I do appreciate it.
It's still going strong, but think I'm going to need a
new Friction wheel before long.
Put on a new, no name aftermarket one not to long ago. 
But it hasn't held up, it appears.
I'm just about out of adjustment.
NorthMaine


Joined: Feb 6, 2015
Points: 2

Re: Ariens Modified & Repowered 1032 (pics)
Reply #58   Feb 7, 2015 4:40 pm
Notice any benefit to the partially closed front of the chute vs open? Machine looks great!
Replies: 57 - 58 of 58Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2021 AbbysGuide.com. All rights reserved.
Site by Take 42