Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hello - purchased a new Honda HS928WAS last year and only got to use it about 3 times last winter. When I did it worked great! We received our first big snowstorm today and I had a hard time starting it. Once it did start, I let it warm up a while and then used it. After about 15 minutes it stalled out. I waited about 15 minutes and started it again and then it worked fine. Went out to use it a second time tonight and the same thing happened - about 15 minutes into it and it stalled out. However, this time I can not get it to start again. I have used all new gas this winter and have no idea what can be causing this. I thought Honda's were known for their easy starting and reliability, which was the major reason I purchased it. I am ready to sell it and go back to old, reliable snow shoveling. :) Appreciate any suggestions. Thanks for the help!

MN_Runner wrote:
I was going to suggest Sea Foaming in an enclosed garage to clean out carbon deposits on a brand new Honda engine, but all that do is cause asphyxiation of the operator and alter the stoichiometry of the fuel-starved engine. 

The problem seems to be fuel or air starvation.  The gas cap theory seems to be fairly plausible, cheap, and quick to verify.  I'd do that before sending the machine back to the dealer and prepare to apply choice of anal lubricant.

DBV1 wrote:

A few more suggestions: Please do what AA335 suggested.  If your engine starts for some reason and it runs then dies later, you cannot have the choke pulled out since your engine is already warm.  I had a hard time restarting the engine with the choke ON (as I thought I needed to have the choke ON at all times) with a warm engine.  I was clearing my pond this afternoon so my kids can skate.  I had no trouble restarting the warm engine without the choke even the outdoor temperature was 15F.

Try this (page 57 of the manual) then put in new fresh gas. http://powerequipment.honda.com/pdf/manuals/00X31V416000.pdf

This may not work and it is up to you to try it.  Hopefully your garage is not too cold.

MN_Runner wrote:
this can be a real problem and while it doesn't happen very often if the vent in the cap becomes clogged with debris it will not allow air into the tank to replace the gas that the engine is burning.  If you can not get air into the tank the carb will not get fuel as a vaccum becomes present in the tank and the gas just wont flow to the carb.
 
Removing the gas cap and breaking the vaccum after the engine dies out and waiting a minute or two for gas to flow to the carb and fill the bowl before starting will verify if the cap is the culprit if the engine starts easliy.

MN_Runner wrote:

This is a common Tecumseh problem due to a defective gas cap design.

http://www.youtube.com/watch?v=Ah14EnPhdUQ

Thanks for the information and learned one new trick.  I just wish changing the timing belt is as simple as the gas cap change.  AA335 is one smart dude!

MN_Runner wrote:
Hah!  That's just me smoking. 



By the way, changing timing belt is fairly simple, it's all the other stuff around it is complex. 

The Honda engine has a gas shutoff valve that is counterintuitive.  IE: it may be off when you think it is on.  Tuning it to the right (viewed from above) makes it open and vice versa.  So...make sure you got it in the on position and see what happens.  Sure looks like a fuel problem, and this could be it.  I had a similar problem with my Honda right after I bought it (stupid me - when all else fails, read the manual).

Should have purchased a Toro! LMAO

Dr_Woof wrote:
Sounds like he was able to run it for two 15 min sessions.  It could be true for the first 15 min run (not much longer than 10 min at full throttle)  but it would be tough to run another 15 min with that shutoff value OFF.  I am agreeing with AA335 gas cap diagnosis although I have no personal experience.

stresst wrote:
That's not going to work.   I have Honda and Toro snowblower and have failed to start the engine several times.  

I don't forget to shut off the fuel valve after using the snowblower, but I do forget to turn it back on when trying to start the engine.   Those damn engines are so hard to start!  Why can't they make them with push button start like on cars??