Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I've repainted my blower housing, impeller, auger and chute (pictures to come) and replaced the impeller bearing and got the engine purring like a kitten.  I've got the whole thing back together...almost, when I notice that there is some play in the axle where it penetrates the tractor housing.  I was going to address the tractor in the off-season but with no snow in the foreseeable future and backup equipment available just in case, I'm thinking of replacing the bearings and any related h/w.

My problem is twofold.  How to disassemble the drive axle and how to identify what needs replacing.  I can't tell if the wear is in the housing or the washer that fills the opening or the bearing or the bearing retainer or all of the above.  When I put the blower on the housing and remove the bottom plate, I wiggle the axle and see some movement in the space between the housing and the washer and possibly between the axle and the bearing.

Looks like I'm going to have to disassemble it to know for sure.  Anyone who has been down this road, feel free to share your experiences.

The parts I was looking to replace, according to the parts manual:

(2)  05417700 Bearing-Ball 1.45 x 2.19 x 0.63
(2)  06417000 Washer-Flat-Steel 1.140 x 1.718 x 0.134

Here's the starboard side:


Here's the port side but the bearing area is not visible:

manjestic wrote:

This is curious and must be a typo (1.45).  Ariens Parts Radar does show the dimensions for the bearings as being 1.45 x 2.19 x 0.63.
But the axles are 1 1/8" (1.12) OD.  The ID of the axle washer is 1.14 and any searches for the bearing (05417700) sold by different parts places
show the bearing ID as being 1.129 .  

jrtrebor wrote:
I referenced the Ariens Parts Manual (part no. 024046E dated 7-95).  I verified that the typo was not my doing.  Good catch.

Thanks for all the advice and wisdom.  I'm sure we'll get a blizzard as soon as I snap off the first rusty nut clear.

Dismounted the axles two nights ago...snow's coming.  I think those two events are cause-effect.

manjestic wrote:
Please continue to take it apart, I heard there might be some snow heading for us too.

I agree, continue to dismantle that snowblower.  A big storm is coming this way.  Nobody buy another snowblower!

Good thing I have backup machines.  I'm storing my brother-in-law's 6.5hp Craftsman and I have a Toro CCR 1000.  My neighbor comes by occasionally with his Bobcat with a poly blade, too. 

I was wondering why you were so brave to open up the snowblower in January.  Yeah, I got a back up snowblower too, and that one has its back up.  :)

Ordered new axle bearings.  I now am checking other wear items in the reduction gear drive.  New concern...when I disassembled the differential, I didn't notice parts 36 or 39 as shown below.  I'm wondering if they are missing or perhaps I have the wrong parts manual.  Anyone?  Bueller?

36 and 39 and pressed into the small axle hub.  They have to be hammered out.  They are bronze bushings.