Abby's Guide to Plasma TVs
Username Password
Home Discussions Reviews More Guides

Member Profile


scottybooj

Name scott
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 2
Number of Posts 2
Number of Reviews 0
Date Joined Feb 3, 2009
Date Last Access Feb 3, 2009 11:52 pm
scottybooj's last  
Re: 826 LE Toro auger/tranny question
#1   Feb 3, 2009 11:42 pm
thanks...so that would be the shear bolt at the end of the axle near the housing?

thanks.
826 LE Toro auger/tranny question
#2   Feb 3, 2009 10:32 pm
Hi, I have an '05 or '06 826 LE.   Just ran over some garden hose tonite.  Cleared it out ok.  The right hand auger now spins freely when you use your hand.  The left hand side auger still remains locked when you try to wiggle it.  When I engage the auger, both sides spin,  but I know the right hand side should not spin when I use my hand.

So, is this a stripped helical gear?  What about thrust bearings/  Are there pins on either side of the drive shaft?  I'm concerned because one side is able to move in either direction while the other doesn't.  Are there two separate gears inside the housing?  

Any advice?

Thanks.
Plasma TVs Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2019 AbbysGuide.com. All rights reserved.
Site by Take 42