Abby's Guide to Plasma TVs
Username Password
Home Discussions Reviews More Guides

Member Profile


Name AJ Klimeck
Email Address private
Gender Male
Location Colorado
Personal Quote
Privileges Normal user
Points 76
Number of Posts 76
Number of Reviews 0
Date Joined Nov 28, 2007
Date Last Access Feb 7, 2019 10:42 am
ajallen's last  
Re: Replacing carburetor on Toro Lawn Mower Model #20439
#1   May 17, 2016 6:50 pm
the engine was made for toro by briggs & stratton Briggs part number 497721 carburetor NLA but will give you more to google for
Re: Replacing carburetor on Toro Lawn Mower Model #20439
#2   May 17, 2016 3:08 pm
Stamped in to the valve cover will be some engine numbers post those.
Re: Honda GX340 engine type????
#3   Aug 11, 2015 10:30 am
Honda power equipment does not use general purpose engines You need the the model & serial number of the machine to find parts> however your coil is part number 30500-ZF6-W02
Re: Toro 824 Power Shift will not move in any direction
#4   Feb 10, 2015 3:38 pm
I would repair it there is no better machine than a Toro Powershift.
Any competent technician should be able to remove a Powershift Transmission in 15 min or less!!

The steps are(from memory):
1 Drain the gas
2 remove the top belt cover pull it to the right side
3 tip the machine up on the bucket
4 disconnect the linkage at the transmission & remove the small plate that covers the transmission
5 rotate the wheels until you see the master link & remove the master link & chain
6 remove the wheels
7 remove the 2 shoulder bolts that form the pivot of the powershift & remove the axle assy
8 remove the lower belt cover
9 remove the plastic retainer for the cable on the right side & slide out the barrel end of the cable
10 lower the pivot latch assy
11 remove 2 bolts on either side that hold on the transmission mount to the machine
12 push the transmission up & remove the belt
13 pull the transmission mount out
14 remove the 4 bolts that hold the transmission to the mount
15 remove the forward/reverse cable from the transmission

reverse to assemble after repair

It is likely that the forward/reverse collar is broken(but could be anything!) Post back with what you find!
Re: Poulin rear engine engine pulley question
#5   Dec 15, 2014 12:31 pm
I think that the cap in the middle needs to be removed and you will find a bolt holding it on.
Plasma TVs Guide   •   Discussions  Reviews   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2019 All rights reserved.
Site by Take 42