Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides

Member Profile


sodamark

Name Mark Soderberg
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 1
Number of Posts 1
Number of Reviews 0
Date Joined Dec 31, 2010
Date Last Access Jan 1, 2011 10:44 am
sodamark's last  
Re: Toro CCR 2000, no spark from plug wire
#1   Dec 31, 2010 4:17 pm
As of yesterday, I had similar problems. No spark. Tried a new spark plug and that did not work. The writeups and advise on this post have been invaluable. Thanks everyone. Miller87's pics and summary were very helpful. I followed the same proceedures and actually ordered the stens module from the same supplier. The machine had never run this well since I purchased it ten years ago for 40 dollars. Sadly, after ten minutes of running, it quit as if the key had been turned to off. I pulled the spark plug and there is no spark again. Can these modules blow out that quickly? Could a bad coil cause it to fail? I clipped the wire from the old ignition module and used the wire nut provided to tie it the new wire. I used the negative wiring diagram for the module. Perhaps it's a defective module? Thanks for any thoughts or ideas. Mark
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42