Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Stalling under load; Tecumseh HSK70 7 Hp

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
grump


Joined: Jan 14, 2008
Points: 58

Stalling under load; Tecumseh HSK70 7 Hp
Original Message   Dec 20, 2008 10:13 am
Have an HSK70 7 hp engine that's been used about four years which is  mounted on an everlasting and loved old Ariens chassis from 1971.

Ran great until first use this season.  I'll preface this by stating that last spring I shut off the fuel line and drained the carb.  It's the first year I've done so little for seasonal storage.  There was about 1/4 tank of fuel.  The snow blower has seen light use with only one curb cut and 20' of driveway.  My estimation is maybe 16 hours of use.

This year I filled the tank, it started right up and made it about 100' from the shed to the driveway.  There's where the problem began.

It stalled under load.  Ran fine at idle but as soon as I engaged the drive belt and demanded something from it; stall.  Setting the choke to 1/4 (the first notch) seemed to help, but the problem persisted.  I tried tweaking the needle adjustment on the carb.  It started at 1 5/8 turn from a gentle bottom, and seemed to run best at that position.  I tried tweaking it both with the drive belt engaged and disengaged.

It idles fine but just plain stalls under a load. 

What should I do?
This message was modified Dec 20, 2008 by grump
Replies: 11 - 14 of 14Next page of topicsPreviousAllView as Outline
grump


Joined: Jan 14, 2008
Points: 58

Re: Stalling under load; Tecumseh HSK70 7 Hp
Reply #11   Jan 18, 2009 9:14 pm
Original poster here.  It's still running like new, just flawless in today's storm and a pleasure to use.  Thanks again for leading me in the right direction.

Was hoping to find an answer about adding a fuel filter to minimize chances of another clogged jet.  I assume there is an engineering reason why it didn't come with one back in the 70's, but is it OK to add a small one just before the carb?
borat


Joined: Nov 10, 2007
Points: 2692

Re: Stalling under load; Tecumseh HSK70 7 Hp
Reply #12   Jan 18, 2009 9:34 pm
No reason I can think of to not install a fuel filter.  I'd put it between the shut off valve (if it has one) and the carb.  I wouldn't go too small.  I like to use the $3.99 Canadian Tire clear plastic filters.  They're big enough to provide many years of service yet small enough to install in limited spaces.  Being clear plastic, it's easy to see if it has contamination in it.   
niper99


Location: London Ont
Joined: Dec 2, 2007
Points: 354

Re: Stalling under load; Tecumseh HSK70 7 Hp
Reply #13   Jan 18, 2009 9:50 pm
grump

yeah defintly add the the fuel filter it will save u a lot of headachs in the future. tecumsech uses a "so called" fuel filter in the gas tank but alot of times people break them open when they clog up from years of service.

grump


Joined: Jan 14, 2008
Points: 58

Re: Stalling under load; Tecumseh HSK70 7 Hp
Reply #14   Jan 18, 2009 10:23 pm
OK, thanks.  Will do. 

Suppose there's no reason to use a small one as I envisioned because a larger one will have less resistance to the gravity fed carb.
Replies: 11 - 14 of 14Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42