Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Toro 824 Snowblower

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
More_Power


Joined: May 27, 2007
Points: 7

Toro 824 Snowblower
Original Message   May 27, 2007 8:55 pm
Hello everyone. First time posting on this forum.

I was given an old Toro 824 for free. I think it's a 1989 model. I never owned a snowblower so I don't know much about them. The only snowblowing I did was with my two arms and a shovel.

I just dismantled the blower in my garage because of rust all over and are in the process of painting the engine shroud peices, the entire auger assembly and shroud, and the wheels. I took off the carb and cleaned it also. It ran great before the teardown and hope it runs better when I'm finished.

I just have some questions;

1) I purchased a new muffler but there was no gasket with it. The old muffler had no gasket either. Should there be a gasket?

2) What engine oil should be used?

3) What type of spark plug? (I just want to be sure it has the correct one)

4) Should there be oil in the auger gear assembly? I read somewhere grease is only needed.

5) Should there be an air filter? I didn't see one attached.

Here are some images.

The teardown...




Here is the painted engine shroud and auger shroud...



Here is the cleaned carb with newly painted linkage bracket...




Many more things to do...

:)

This message was modified May 27, 2007 by More_Power
Replies: 1 - 19 of 19View as Thread
Replies: 1 - 19 of 19View as Thread
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42