Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hi:

Greeting from Connecicut .I have a new Ariens 8526 which I bought last year from HD . It is basically new, worked great last year. Tried all morning to get it to start. Here's my settings:

1) Fuel switch is on

2) Choke is on full.

3) Throttle set for cold (one position up from stop)

4) Primer button pushed five times (while covering vent hole)

5) There is fuel in the tank

Tried both the elec start and the hand pull, it will not start. Everytime I push the primer bulb, fuel spills out on the ground from a spring loaded pin type thingy. It almost started a few times with the elec start, but it would not keep running. Any suggestions?  Thanks!

perhaps its floded?

usuall  only prime 3xs.\\

also maybe turn the choke toward the middle.

good luck

Did you store it with old fuel in the tank? It sounds like its flooding or the carb is dirty from old fuel. The float could be stuck. Normal start position is full throttle, full choke, one or two hits on the primer.

Marty

I had the same problem today with my 8524. Good fuel, good prime, choke on, blower was stored indoors.

....No matter how many times you pull it over, if the key is "Off" it won't start! Doh!

abcdef wrote:

I would bring the throttle all the way up, then back it down to just before the full throttle mark, you should feel a click when its all full, then back it down.  Give that a try and I bet it will kick right over in a few attemps if not the first try.

THanks to all who replied. Old fuel was not a factor, but I finally got it to start using two tricks: I pumped the primer about five imes until I felt the pressure increase behind the bulb, hen I adjust the throttle to just above the "Turtle" setting (Exactly as suggested by E Green above). She cranked right up. I wrote the settings on a 3x5 card and tapped it to the instrument panel for future reference.

Hopefully none of us will need our snowblowers again between now and Spring

Best Regards from Connecticut, Pete

glad you got it going, careful with priming it that much, you should prime as little as needed, to much you could flood and cause some problems.  Other than that enjoy snowblowing!