Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Snagged A Kubota!
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
Majorxlr8n
   
Location: Freehold NJ
Joined: Aug 5, 2003
Points: 1092
|
 |
Snagged A Kubota!
Original Message May 5, 2005 9:28 pm |
|
Well, I grabbed another one - an 8 year old Kubota T1400H, 13.5hp lawn tractor with hydrostatic drive, 40" cut with dual bagger, needing work for $500. The engine sounded like it had marbles rolling around inside - the valve clearances were ULTRA excessive, but a quick adjustment quieted things down nicely & the engine runs sweetly. The deck is a mess - it needs all new spindle bearings, new blades, & 2 deck hangers rewelded back on. The blades are SO BAD that they look like they were ready to disintegrate in hand grenade fashion at any time (I kid you not). The tractor loses speed going uphill or around turns, so I changed the hydro fluid with genuine Kubota fluid. Its not as bad, but could use improvement. I'll check the drive belt to see if it might be slipping, but have no other ideas on how to proceed if the belt tension is good - can anyone please give me some direction? Thanks! Marty 
|
Majorxlr8n
   
Location: Freehold NJ
Joined: Aug 5, 2003
Points: 1092
|
 |
Re: Snagged A Kubota!
Reply #8 May 6, 2005 9:33 pm |
|
Bill D - If you were closer, I would snag that old Toro!!  I went back to the Kubota dealership Friday to obtain all my parts (4 deck spindle bearings & 2 blades) for the whopping cost of $44. The counter man told me this tractor retailed for over $3200 back in 1999 WITHOUT the bagger! I didn't get to work on it as my lawn was in dire need of a cut. I'll try to get some pics up later today... Marty 
|
Majorxlr8n
   
Location: Freehold NJ
Joined: Aug 5, 2003
Points: 1092
|
 |
Re: Snagged A Kubota!
Reply #9 May 15, 2005 3:44 pm |
|
Sorry - I didn't take a before pic  , but here's a finished product: 
I changed the hydro & differential fluids, cleaned the filter screen & no change. I checked the plastic idler & it was about 90% GONE. A new Kubota idler was installed ($45 for a plastic pulley - OUCH!) & that cured it. I have a few hours in this one, hence my absence lately - sorry it took so long to post a pic... Marty 
|
cleanmaxx_brian
   
"At least I am enjoying the ride"
Location: Wantagh, Long Island, NY
Joined: Mar 11, 2005
Points: 231
|
 |
Re: Snagged A Kubota!
Reply #11 May 15, 2005 7:02 pm |
|
$500 bucks for that??? You lucky dog!!! That was a SCORE!!! You can make good money off that for sure!
Brian ChangAriens 8526LE, Bradley 32" 12.5HP walk behind mower, Echo BP200 blower, Troy Built 4.5HP Pressure Washer, Craftsman 4.5HP Yard Vac, Homelite line trimmer, Scotts 21" high wheel mower, MTD 3.5HP Edger.
|
|
|