Abby's Guide to Plasma TVs
Username Password
Home Discussions Reviews More Guides

Member Profile


Threelabs

Name Patrick
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 1
Number of Posts 1
Number of Reviews 0
Date Joined Oct 19, 2019
Date Last Access Oct 21, 2019 6:11 am
Threelabs's last  
Miele Antares Canister Repair Story
#1   Oct 19, 2019 1:29 pm
Have had a Miele Antares canister vacuum for 13 years, worked great, but suddenly the power switch stopped working. Couldn't turn it on. Talked with two vacuum repair shops, one of which actually took it in and checked it out. Both were off the mark on troubleshooting. The shop that actually looked at it said it was the motor (a dead spot?), and would cost $ close to buying a new vacuum cleaner. So I took the vacuum cleaner home and disassembled it all the way down to removing the cord reel and electric motor. I must say, Miele designs their vacuums well. Easy to figure out how it all comes apart. It took me ~ 30 minutes to work through the disassembly without a manual (or Youtube). I did it a few times over the course of working with the shops, but with a little practice, the vacuum can be disassembled and put back together in 5-10 minutes. Kudos to Miele. Back to the troubleshooting - I first checked continuity of the electric circuitry with a multimeter, from the cord plug (prongs) all the way to the switch and printed circuit board (PCB). Everything checked out, including the motor. I then checked the presence of AC voltage with a standard non-contact probe, and voltages were present where it was supposed to be. Then I MEASURED THE ACTUAL VOLTAGE at locations in the circuitry where 120 volts should be present, starting from the switch, PCB, motor, etc. All I could measure was 2.5 volts. Then I checked voltage where the cord (=line voltage) comes in to the uptake reel. Still 2.5 volt. Cord issue starting to become apparent. Then I cut the cord, literally, about 6 inches from the machine end (uptake reel) and measured voltage again - the cord covering had cracked in that location, exposing black (hot) and white (neutral) wires, although the actual insulation of those wires was intact. Must be lots of wear and tear on the cord from reeling operation. But still 2.5 volts present. Ultimately, it was the plug at the end of the cord, where it plugs into the wall outlet. Geez, all it took was a $3 part (new plug) to fix it, but it took some time and effort to figure it out. The moral of the story is this: Its easy to disassemble, troubleshoot, gain accessibility to critical components to interrogate, and reassemble the machine within minutes. As a side note, I inadvertently wound the cord reel (spring) too tight, and the end of the spiral spring jumped out of the small uptake reel. I thought the uptake reel was hosed at this point, but I was able to thread (literally) the end back around the small reel and the spring started winding back like a charm. Phew.
Plasma TVs Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42