Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides

Member Profile


severtki

Name Kirk Severtson
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 3
Number of Posts 3
Number of Reviews 0
Date Joined Aug 10, 2009
Date Last Access Aug 12, 2009 1:03 pm
severtki's last  
Re: How to replace spark plug wire -- not removable from magneto?
#1   Aug 12, 2009 1:03 pm
Got the part and popped it in.  One pull and the darn thing fired right up!!

Now I need to tune it up, as I'm having trouble getting the right mix and it's hard to start...

Thanks for the advice!
Kirk
Re: How to replace spark plug wire -- not removable from magneto?
#2   Aug 11, 2009 12:23 pm
niper99 wrote:
first off by looking at your picture l would make sure your flywheel is rust free and also clean the coil (u can do this with emery cloth/fine sand paper or an sos pad), before u say the coil is no good. but in my experince coils rarely go bad and by this picture l'm looking at theres a good chance its to rusty!!, l assume u replaced the spark plug?, the only other thing it could be is the ground wire has a short to ground some where (bare wire touching the block).lets say the coil is bad than yes u will need a air gap of 0.10. the spark plug wire is not replacable on its own.

The coil isn't bad, AFAIK.  The wire end, connection to the spark plug (new plug) has corroded and broken off, so I need to replace the wire.  As you and whitetail say, it looks like there's no way to replace the wire (I guess it's different than on cars...), so it sounds like this is the part to replace...

Thanks for the info -- I'll post back with my results once I get the part.
How to replace spark plug wire -- not removable from magneto?
#3   Aug 10, 2009 6:53 pm
I have a 8hp B&S engine and need to replace a spark plug wire.  It doesn't appear to be removable from the magneto.  Do I have to replace the whole darned magneto armature?
<pic snipped>
Part according to the parts manual:
<pic snipped>

Anything I should know about doing this, like being careful to get the right gap, etc?

Thanks in advance,
Kirk
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42