Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides

Member Profile


flattop

Name Jacques Poirier
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 2
Number of Posts 2
Number of Reviews 0
Date Joined Jan 21, 2016
Date Last Access Jan 24, 2016 7:45 am
flattop's last  
Re: 2011 ariens platinum 30 with B&S OHV 342 cc engine backfire through exhaust.
#1   Jan 23, 2016 9:14 am
Thanks for the reply Mike

I noticed  the intake valve was blueish at the bottom of the stem.Sure sign of overheating .
I'm thinking maybe a used head that did not overheat would solve the problem.A new  complete head is to expensive with the low Canadian dollar.
Although I got the blower for nothing it's only worth about 800-900& in good condition.
The cylinder has minor scoring but it ran fine till it backfired.
Seems like a lot of complaints about this engine.Ariens only used them 3 or 4 yrs.Hope there new AX engines are better,they do have a cast iron sleeve.
They should have stayed with the Techumseh , engine but cheaper is always better for the line..sometimes.
DO you think  it's worth while trying the used head?

Thanks
Flattop
2011 ariens platinum 30 with B&S OHV 342 cc engine backfire through exhaust.
#2   Jan 21, 2016 6:39 pm
Help!
Last week a  friend gave me his 2011 Ariens snow blower.He told me it backfired a few times and he couldn't start it after that.  It's in real good shape but the engine would not start and was hard to turn over.

I removed the valve cover and found the aluminum  push rod on the exhaust side bent and out of place.After removing the head I then removed the valves and found that the valve guide on the exhaust side
was almost completely out  it's sleeve.The intake side push rod was also bent but the guide was fine. .I pressed the guide back in place replaced the two push rods and installed the head with new gasket.
After adjusting the valves at top dead center, I put everything back together and started the engine.It fired up right away and ran fine.After blowing a bit of snow I turned down the throttle to idle and the engine backfired through the muffler.
It started easy again at full throttle and I backed it off slowly and turned it off.That was yesterday. Today I took the valve cover off to check and the valve guide was out again and the push rod on the exhaust  side was bent again.
Any ideas on what is happening would be appreciated.
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42