Abby's Guide to Hair Loss
Username Password
Home Discussions Reviews More Guides

Member Profile


hcd724

Name Henry
Email Address private
AIM
YIM
ICQ
Gender
Age
Location
Personal Quote
Privileges Normal user
Rank
Points 1
Number of Posts 1
Number of Reviews 0
Date Joined Jan 26, 2008
Date Last Access Jan 27, 2008 10:44 am
hcd724's last  
Re: Fuel Leaking Out of Tecumseh HM80 with 632334A carb
#1   Jan 26, 2008 4:38 pm
I'm happy that  stumbled upon ths thread. My stepson gave me his old Ariens ST824 (model 924050 w/ Tecumseh 8HP). It stopped running so he went out and bought a new snowblower. Being the tinkerer that I am, I did some troubleshooting and determined that it was the carb that was faulty.  So I went to my local Ariens dealer and purchased a rebuild kit for the carb. After I rebuilt it, I installed it back on the motor. As soon as I opened the gas valve, gas started pouring out of the primer outlet. I was sure that I did everything right so I took it apart again but didn't see anything wrong. I Googled my problem - low and behold, I found this thread. I'm happy to say that it turned out to be that I put the grooved side of the needle seal towards the bowl. I flipped it around and seated it using the shaft of a drill bit, put it all back together, and voila! No more gas leaking and it started right up! Thanks guys, I appreciate the tip.

Now I need to tweak the adjustments on the carb. It runs fine at near full throttle with the choke 3/4 on (which I'm sure is not right) and stalls out at mid to low rpms. What's your advice fine tuning the carb? I did one and a half turns from closed on the screw at the bottom of the bowl. Should I tweak this one out some more - maybe 2 turns?

Your advice would be greatly appreciated.

 

Hair Loss Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42