| Name |
Dan Diskin |
| Email Address |
private |
| AIM |
|
| YIM |
|
| ICQ |
|
 |
| Gender |
|
| Age |
|
| Location |
|
|
| Personal Quote |
|
|
| Privileges |
Normal user |
| Rank |
|
| Points |
4 |
| Number of Posts |
4 |
| Number of Reviews |
0 |
| Date Joined |
Feb 18, 2007 |
| Date Last Access |
Feb 20, 2007 12:15 pm |
|
 |
Re: ariens 8hp 24 in mod910018 bearing housing cracked
#1 Feb 20, 2007 7:12 am |
|
Ralph and Mech12, Thanks for the advice. My unit has drive system with hex shaft inside of frame. It doesn't look like I can slide the wheel left or right to get off shaft. It looks like I drop the whole drive unit out. The housing that is cracked is a #10547. Just one ear is broken and it doesn't seem to affect the performance so I might leave it. Thanks again. dan |
|
|
Re: carb adjustment
#2 Feb 19, 2007 10:20 am |
|
Bottom screw out 1.5 turns. Side out 1 turn. Clean carb with gumout and put in a new plug. I also dropped the bowl to clean out and make sure float doesn't have a leak. dan |
|
|
Re: ariens 8hp 24 in mod910018 bearing housing cracked
#3 Feb 19, 2007 7:02 am |
|
mech, Thanks I downloaded that over the weekend. I just know from looking at it it will be a pita. Any advice on changing the rubber drive wheel? I am trying to figure out how to dissasemble the hex drive axle. Thanks dan |
 |
ariens 8hp 24 in mod910018 bearing housing cracked
#4 Feb 19, 2007 4:43 am |
|
Hope someone can help. My old ariens needs a new friction disc so I purchased and went to put on. I then saw the aluminum bearing housing has a break in it and I cannot figure out how to get friction disk on and I don't know if I want to tackle the bearing housing. How tough is this going to be on me. Help. Thanks dan |
|
