| Name |
Adam |
| Email Address |
private |
| AIM |
|
| YIM |
|
| ICQ |
|
 |
| Gender |
|
| Age |
|
| Location |
Maine |
|
| Personal Quote |
|
|
| Privileges |
Normal user |
| Rank |
|
| Points |
2 |
| Number of Posts |
2 |
| Number of Reviews |
0 |
| Date Joined |
Oct 25, 2006 |
| Date Last Access |
Oct 28, 2006 6:41 pm |
|
 |
Re: Voltage but no spark on chainsaw
#1 Oct 28, 2006 6:40 pm |
|
I tried yet another new sparkplug...and nothing. I actually pulled out the switch this time (duh) and tested continuity, and the switch IS working. Back to square one. A short somewhere? Could it be the coil not sending enough current to the spark plug? I know very little about cranking electricity--Shouldn't I get an amp reading on the multi-meter when I pull the cord?
|
 |
Voltage but no spark on chainsaw
#2 Oct 26, 2006 5:39 pm |
|
I have a Husqvarna with CD ignition. Haven't used it for about 6 months. Was working fine when I put it away. Now I'm not getting any spark with the plug I left in, nor with a new plug. I put my multi-meter on it and am getting AC voltage at the spark plug lead when I pull the cord. Don't know if this has anything to do with it, but when I check for continuity through the switch, I get a complete circuit with the switch ON and OFF. Should I be? Any suggestions on further diagnostics? Could both plugs be bad?
|
|
