Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Honda HS621 restoration

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
jrtrebor


Location: Michigan - 3 hours north of Chicago on the lake
Joined: Feb 10, 2010
Points: 539

Honda HS621 restoration
Original Message   Oct 27, 2013 8:57 pm
Well here is my most recent find.  Actually I bought it at an auction back in August.
But didn't get around to restoring it until earlier this month.
It was pretty rough but started on the second pull. So figured it
was worth the 40.00 I paid for it.


   

The upper handle was pretty messed up.  So I replaced it with one that I kept around from and old Toro CCR2000.
It bolted right up and was also a little longer than the stock Honda handle.  Which is nice.





Stripped and repainted the muffler cover.  As well as the lower handles.


 

The blower housing sides needed quite a bit of straighting.  Also welded on a small piece of steel onto the bottom of the left  side
where it had been worn off.  Not adding the piece would have allowed snow and water to get inside what is the belt and pulley
compartment.  That would not be good.  Installed a new set of paddles and a new scraper that I bought on ebay for $53.00

 


Cleaned up everything inside.  Have to say that these blower are really well built.  The steel used for the bucket and the
undercarriage is heavy gauge.  Actually the undercarriage is plate steel.  The bracket between the engine and the bucket
is like something you would find in a automobile.

 

Sandblasted the bucket and sealed some of the joints with auto Spot putty.  Gave it two coats of Rustoleum Red oxide primer.
Then two top coats of Krylon Tough Rust semi gloss.  I did end up giving the center interior section of the housing another
coat of black Rustoleum Hammer finish.  That gave it a smoother, slicker finish and that paint if extremely durable.
That is also what I painted the auger with.

 



 

Didn't do much else other than check the carb bowl for dirt or signs of water. 
Replaced the plug, oil was good and clean.  Belt was good.  So it's ready to go.

In case some of you noticed there is a modification that I made.  I designed a chute rotator system for it.
Which I will show in another thread.


This message was modified Jan 2, 2014 by a moderator
Replies: 78 - 78 of 78Next page of topicsPreviousAllView as Outline
jrtrebor


Location: Michigan - 3 hours north of Chicago on the lake
Joined: Feb 10, 2010
Points: 539

Re: Honda HS621 restoration
Reply #78   Dec 16, 2014 7:07 pm

Ebay

http://www.ebay.com/itm/Honda-HS521-HS-521-HS621-Snowblower-Snowthrower-Auger-Assy-72400-747-A12-OEM-/330779201700?pt=LH_DefaultDomain_0&hash=item4d03fa10a4
Replies: 78 - 78 of 78Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42