Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I just bought a new 2009 Ariens 20" 2-stage snow blower, model 920007.  It is the smallest 2-stage snow blower I could find and it is now discontinued.  Its gear case comes with Ariens L2 oil.  I've read there is a new Ariens L3 synthetic gear case oil that is superior.  It says to use Ariens grease, part number 00036800.  This is Sten Mix Hi-Temp grease.  Does anyone know if this grease is synthetic?  Is this the best grease to use?  It is a black grease that looks like lithium moly grease.  It does not look or feel like waxy red high temp grease.

I would not want a high temp grease on a snowblower, more a low temp grease, one that won't harden, one that is highly resistant to washing off from water.  I use Amsoil's synthetic grease, and they make one for water resistance used on boat trailer hubs.  I have always told my car dealer to never grease the door hinges.  They always use the Lithium Spray Grease, and all they do is cause the cars door jambs to be coated in this hard dirt encrusted crud that I have to clean out.  I use synthetic grease because it doesn't harden, and I shield the metal around the hinge pins that require the grease with paper towels befor I spray using the thin wand on the spray can that the dealer shop tech never uses.

Anyone come across this grease?

Green Grease

I saw it at Autozone, $7.99 for 3 3 oz tubes or $7.99 for 1 14oz tube.

Multi-purpose Synthetic Polymer Grease...Industry Proven for Over 25 Years

Waterproof Green Grease™ is a professional-grade high performance synthetic polymer grease developed for mining, manufacturing, marine and off-road. Re

Recommended for cars, trucks, boats, trailers, ATV's, motorcycles, mowers, farm equipment and implements - any application up to 500° F.

edge130 wrote:
Doesn't list snow blowers so, I guess you can't use it....

Sounds like it might be a good quality marine grease.  I'd use it without hesitation. 

If you're looking for a grease for the auger shafts, I think the only purpose of said grease is to (a) provide a bit of lubrication (b) stay in place (i.e. its sticky) (c) keep surfaces from rusting. I'm with Borat... we're not talking about lubricating the differential on an F1 car here. We're talking about machines with huge tolerances, low stress, and few running hours.

This is from Ariens in response to my question on this subject: Hi , Thank you for contacting the Ariens Company. Any lithium grease that resists water is good to use. Sorry the oil can is a little mis-leading, This is a carry over from older units. In these areas, you can use the same grease. On the hex shaft, use a very small film so it does not build up and get onto the drive plate or drive disc. The oil can symbol he is referring to is on the lube chart in my owners manual , along with the grease gun symbol. I have a 2011 Deluxe 30. The grease I told him I intended to use is Valvoline 615, General purpose lithium grease for GM, Chrysler,European and Japanese cars resists water wash out,NGLI 2, extreme pressure, -10 to 380 degrees. That is a lot lower temp than the Stens stuff which is more relevant that the higher top end for the Stens grease. It is not going into high pressure, high speed bearings so high temp limit means much less than how cold it can work. It is a regular 14.1 oz grease sleeve carried by all the big auto chains for around $4.59.