Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > bel;ts slipping ?

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
jett


Location: SouthWestern Ontario
Joined: Jan 24, 2005
Points: 5

bel;ts slipping ?
Original Message   Jan 24, 2005 11:06 am
I have a 10hp 28" MTD model 660 2 stage blower w/ aTec Sno King motor. This unit has seen only two winters. The problems I'm experiencing is with the unit not throwing snow worth a dam ,until the auger and impeller has been running at least one pass up the drive (50 yards.) The motor runs strong and fine. The wheel engagement was sluggish yesterday as well. Could this be a simple case of needing to replace the belts. It would seem that once the belts warm up it works fine. Any and all comments are welcomed.
Replies: 11 - 11 of 11Next page of topicsPreviousAllView as Outline
AJace


I have an Ariens 926 Pro because I like Orange



Location: Near Gettysburg
Joined:
Points: 969

Re: bel;ts slipping ?
Reply #11   Jan 27, 2005 12:55 am
On my Ariens it says I need to tip the unit apart between the frame and auger housing.

I wonder if Jubol's snowthrower is designed the same way?  If so Jubol, do you have any plans on changing that like you did your oil valve?  Would love to see picture of this process.

Ariens 926 DLE Professional; Toro S200; Craftsman LT1000, Echo ES-230;

Replies: 11 - 11 of 11Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42